Views:0 Author:Site Editor Publish Time: 2019-07-11 Origin:Site
Badge makers must carry out the production and production of badges in accordance with the relevant laws and regulations of the country. Today, I will tell you about the steps of making quality inspection custom pin badge after the badges are completed.
1, the first to carry out the strength test, the strength of the badge is also produced in accordance with the relevant regulations, can not be lower than the standard of the badge, in order to meet the needs of customers, increase the useful life of the badge.
2, falling ball impact, the badge face up, horizontally spread on the concrete floor, a steel ball free fall to the center of the badge, repeated impact three times, observe the surface of the badge crack or delamination, etc., if this occurs The situation proves that the police emblem is unqualified.
3, fall test, the badge is suspended at a height of 1 meter from the ground, free fall two or three times, if there is no crack or delamination, it means that the quality of the badge is qualified, can be shipped.
The above is the step of the badge test for everyone. If you still have something you don't understand or want to know about other badges, you can contact us at any time or visit our company's homepage for consultation. I hope to help you!
The above is an introduction to the pin badge wholesale makers about the quality of the badge production.